Next Up Previous Contents Index
Selecting Services for Start on Reboot

6.4 Selecting Services for Start on Reboot

Please Note: If you're performing a workstation- or server-class installation, this part of the installation is automatically done for you. Please skip ahead to Section 6.5.

Next you'll see a dialog box entitled ``Services'' (see Figure 63). Displayed in this box is a list of services with a check box by each. Scroll through this list, and check every service that you would like automatically started every time your Red Hat Linux system boots. If you're not sure what a particular service is, move the highlight to it and press [F1]. You'll then get a brief description of the service.

Figure 63: Selecting Services

Note that you can run /usr/sbin/ntsysv or /sbin/chkconfig after the installation to change which services automatically start on reboot.


Next Up Previous Contents Index